How to draw Bugatti Veyron, Divo, Chiron with a pencil step by step

Content

Sports cars Chiron, Veyron and Divo produced by the Bugatti concern have gained immense popularity among fans of high-speed driving. Drawing these models of cars will not be difficult. You can use colored pencils or markers for drawing.

Bugatti Chiron in pencil

How to draw a Bugatti is a question often asked by boys interested in motor racing.

How to draw Bugatti Veyron, Divo, Chiron with a pencil — The article provides detailed instructions on how to draw a Bugatti.

To draw a simple model of such a car, you can use an ordinary pencil.

The drawing is created in several stages:

Place the sheet in landscape orientation.
Draw a curved and upside-down trapezoid, the upper base of which should be equal to 6 cm, and the lower one - 3 cm.
In the center of the lower part of the trapezoid, draw a semi-oval in a vertical position, with the round part pointing upwards. Then you need to shade its inner part.
Draw a stroke around the semi-oval, and then draw horizontally elongated rectangles to the left and right of it. The width of the right rectangle should be 2 times larger than the left one, and the height should be the same. Then you need to erase their corners with an eraser, and then round them with arcuate segments.
Inside each rectangle, draw a slightly smaller rectangle that should be attached to the top corner of the outer rectangle. Then, shade the inner rectangles.
Draw a large rectangle around the trapezoid and rectangles, then erase the left and right upper corners with an eraser. Then round off the left upper corner, and draw a right-curved and downwards corner in place of the right corner. The result will be a hood.
Draw a line parallel to the bottom of the hood and passing through the middle of the small rectangles drawn earlier.
Fix the pencil just below the middle of the left part of the trapezoid outline, and then draw a line to the left, until it connects with the left side of the hood. Then, above this line, draw the left headlight as a small rectangle with a rounded upper left corner.
Fix the pencil just below the middle of the right part of the trapezoid outline, and then draw a line to the right, until it connects to the right side of the hood. Then, above this line, draw the right headlight as a small rectangle with a rounded upper right corner.
Place the pencil in the middle of the trapezoid and draw a line upward, dividing the trapezoid in half.
Above the hood, draw a windshield in the form of a rectangle with rounded corners. The left side of the rectangle should be slightly tilted to the right. Then you need to make an outer outline of the windshield at a distance of 0.3 cm from its contour.
To the right of the hood, draw a wheel in the form of an oval, elongated vertically. Then, inside this oval, you need to draw two more semi-ovals nested inside each other. Between the second and third ovals, along this entire area, draw a series of small triangles, with sharp angles directed toward the center of the wheel. Then you need to place the pencil at the bottom of the wheel and draw a horizontal line until it connects with the bottom line of the bumper.
Place the pencil in the upper right point of the trapezoid and draw a semi-oval directed to the right (car door). The lower part of this semi-oval should connect with the middle of the wheel. Then you need to shade the right part of this semi-oval, and to the left of the shading draw the door handle in the form of a small circle, and an arc coming out of it.
Place the pencil at the right upper point of the trapezoid and draw a line up, parallel to the right line of the windshield contour, then round it to the right and continue to draw the pencil at a distance twice the length of the door. Then you need to draw a line connecting the left vertex of the windshield contour and the middle of the previously drawn line. As a result, you will get the roof of the car.
Place your pencil in the middle of the top of the door outline and draw a line up to where it meets the roof. This will be the side window.
Place the pencil at the bottom right of the wheel outline and draw a line parallel to the bottom line of the door. Then point the pencil upward and draw an arched line that should connect to the roof line of the car.
Draw the second wheel in the same way as the first.
Shade the front of the wheels using horizontal lines.

Bugatti Chiron (front view)

The front view of the Bugatti car looks very impressive. It is recommended to draw this picture with felt-tip pens.

The drawing process consists of the following steps:

Draw a rectangle with a width of 18 cm and a height of 6 cm. Then you need to erase its upper corners with an eraser and round it off with lines directed at an angle of 45° to the central vertical of the drawing.
Draw a semi-oval slightly below the middle of the rectangle, with the round part pointing upwards. Then draw a small oval in its upper part and paint it red. Paint the inner part of the main semi-oval black.
Draw 2 rectangles to the right and left of the semi-oval, then round off their corners. After that, each rectangle must be divided in half using horizontal lines. Then, you need to color these lines gray, and paint the entire inner part of the rectangles black.
Draw a line parallel to the bottom of the bumper and passing through the center lines of the rectangles. Then you need to color the area between this line and the bottom line of the bumper in blue. The bottom line of the bumper needs to be made bolder by coloring it in black.
Above the left and right rectangles, draw headlights in the form of rectangles, the width of which should be equal to the width of the lower rectangles, but the height should be 3 times smaller, and these rectangles should be located at an angle of 20 ° relative to the horizontal of the drawing. Then, inside each headlight, you need to draw 4 small squares located in a row. After this, you need to paint the headlights black, while leaving the outlines of the squares unpainted.
Draw the top of the car in the form of a trapezoid. Then draw another trapezoid inside it, at a distance of 0.5 cm from the outer trapezoid. Then you need to paint the inner trapezoid black. And paint the space between the trapezoids blue.
Color the entire interior area of the car blue.
Draw side mirrors on the left and right of the car body in the form of triangles with rounded corners, which should be connected to the body using tubes directed at an angle of 45° relative to the vertical of the drawing. Then paint the lower part of the mirrors blue, and the upper part black.

Bugatti Chiron (side view)

How to draw a Bugatti is often asked by children who collect toy cars.

To draw a Bugatti positioned sideways to the observer, you need to follow these steps:

Draw a rectangle with a width of 20 cm and a height of 4 cm.
Erase the upper left corner of the rectangle and draw an arc in this place. The result will be the body of the car.
In the lower left part of the body, draw the front wheel in the form of a circle with a diameter of 3 cm, inside which draw 2 more circles, nested inside each other and located at a distance of 0.3 cm from each other. Then paint the area between the outer and first inner circle black, after which paint the area between the second and third circle blue.
In the center of the wheel, draw two small circles nested inside each other. Color the area between them black. Then draw 5 tubes connecting the small and large inner circles. The tubes should widen slightly near the large circle and should be distributed evenly inside the wheel.
In the lower right part of the body, draw the rear wheel similar to the front one.
Place the pencil in the middle of the left side of the body and draw a horizontal line to the connection with the front wheel. Then under this line draw two stripes in blue, located at an angle of 45° relative to the horizontal of the drawing. Then you need to paint the square area around the stripes in black, after which to the left of this area draw a bumper in the form of a square and paint it in black.
In the upper left part of the body, draw a headlight in the form of a diamond, in the upper right corner of which draw a small square and paint it black.
Fix the pencil in the upper left part of the body contour at a distance of 5 cm from the left edge, and then draw a semi-oval directed to the right. The lower part of the oval should connect with the lower right part of the front wheel.
Paint the area between the top of the body and the top of the drawn oval in gray, then divide this area into 2 parts by drawing a vertical line in black closer to the right side of the oval. The result will be the car window.
Paint the left side of the car body blue.
Place the pencil in the middle of the right side of the front wheel and draw a triangle pointing to the right, then color it black.
Paint the right side of the body black.
Above the window outline, draw a roof in the form of a line parallel to the window outline. Then you need to paint the roof black.
On the right side of the car, draw a curved rectangle, the height of which should be equal to the height of the car, and the width should be 2 times less than the diameter of the wheel. Then you need to paint this rectangle black.
Starting from the top of the curved rectangle, draw 2 rectangles arranged in the shape of the letter G and connected to the body. Then you need to color these rectangles black.

Paint the bottom and right parts of the body black.

Bugatti Veyron

How to draw a Bugatti Veyron may be of interest to Formula 1 racing fans.

To draw this car model you need to follow these steps:

Draw a large oval and then erase a small part of it on the right.
Fix the pencil at the right upper point of the oval outline and draw an arched line directed to the right and down. Then, without lifting the pencil from the paper, you need to draw a long line to the left, which should pass through the lower part of the previously drawn oval, after which you need to erase the lower part of the oval, which is under the drawn line, with an eraser. The result will be the body of the car.
In the middle of the body, draw a parallelogram that should occupy half of the inner area of the body. The right side of the parallelogram should be slightly wider than the left side. On the left side of the parallelogram, draw a vertical stripe and color it black. On the right side of the parallelogram, draw a headlight in the form of a rectangle that slightly widens on the right. Then, erase the lower right corner of the parallelogram with an eraser and draw a black rectangle with rounded corners in its place.
On the right side of the body, draw a semi-oval, with its round part stretched upwards. Then, on the top of the semi-oval, draw a small oval, which must be colored red. Then, you need to color the inside of the large semi-oval black.
On the left side of the body, draw a rear wheel in the form of a circle, in the center of which draw a small circle, and around it draw 6 semicircles, which must be painted black. Then you need to outline the wheel with an outer circle and paint the area between the circles gray.
On the right side of the parallelogram, draw the front wheel in the form of a circle, which should extend slightly downwards beyond the parallelogram. In the center of the circle, draw a small circle, and around it, draw 6 semicircles, which must be colored black. Then, you need to outline the wheel with an outer circle and color the area between the circles black.
Color the parallelogram blue, leaving the headlight and wheel out of the way.
Place the pencil in the middle of the top of the car body and draw a curved line down to connect to the bottom of the parallelogram. Then place the pencil in the middle of the top of the body again and draw a curved line to connect to the top of the front wheel. The result will be a door.
Draw several circles inside the headlight, then paint the top of the headlight in black, without touching these circles.

Bugatti Divo

How to draw Bugatti Divo is explained in the following instructions:

On the left side of the sheet, draw a rhombus, each side of which should be equal to 5 cm. Then, along its diagonal, draw a tube slightly expanding in its left part. Then, around this tube, draw a group of decorative elements in the form of curved lines and rectangles, some of which should then be painted gray. The result will be the hood of the car.
Draw a trapezoid bumper under the hood, paint the lower part blue and the upper part black. Then draw the lower part of the hood as a smaller, inverted trapezoid and paint it black.
On the right side under the hood, draw an arc convex at the top, and under it, draw a wheel in the form of a circle. Then inside this circle, draw 2 more circles, located at a distance of 0.3 cm from each other. Color the area between the first and second circles black, and between the second and third - blue. Then inside the wheel, draw a five-pointed star, after which color its outline gray, and color the entire remaining area inside the wheel black.
Draw a trapezoid-shaped windshield above the top of the hood.
Place the pencil in the upper right part of the windshield outline, then draw a semi-oval with the round part extended to the right. The lower part of the semi-oval should end at the point of the arc located above the front wheel.
Place the pencil in the upper right point of the hood outline and draw a horizontal line dividing the previously drawn semi-oval into 2 parts. Then you need to color the lower part gray, and color the upper part black. The outline of the semi-oval should remain uncolored.
Draw the roof of the car by connecting the top of the windshield to the middle of the top of the semi-oval. Then you need to color the roof gray
Place the pencil in the lower right part of the front wheel and draw a line parallel to the horizontal central line of the previously drawn semi-oval. Above this line, draw a parallelogram stretched along it and color it blue. Then you need to draw the rear wheel, similar to the front wheel.
Place the pencil in the lower right part of the outline of the previously drawn semi-oval and draw a vertical line down to the intersection with the lower line of the body. The result will be a door.
Place a pencil at the top right of the door and draw an arched line connecting the door to the top of the rear wheel outline.
Paint the car body grey.
Above the right side of the body, draw a small trapezoid, stretched to the right horizontally, and then color it black. Then draw 2 vertical segments connecting this trapezoid to the body of the car.

Bugatti cars have an elegant appearance and are racing vehicles. Some of these models require special drawing of components, but in general, drawing these cars can be mastered not only by adults, but also by school-age children.

Video about drawing bugatti

How to draw a Bugatti car step by step: